Currently I own a .6 inch Gear Essentials Master cock ring in addition to a .2 inch Titan. Recently, I discovered a 1 inch stainless steel cock ring on the Internet so out of curiosity I decided to install the Master and then cap it off with the Titan so to effectively create a .8 inch cock ring. Wow! This was a great feeling, slightly tighter but very stimulating.



I am considering the purchase of a .4 inch Titan together with a .6 inch Titan so that I can stack the two rings together. I am also considering the purchase of two .6 inch Titans for an effective width of 1.2 inches however this may prove to be too much.



Has anyone tried stacking Gear Essential cock rings and if so what is your opinion of both a 1 inch width as well as a 1.2 inch width?



In my opinion Gear Essentials should really introduce a 1 inch Titan. I know that I would buy it, especially in the charcoal finish which I love.



They also should introduce powder coated cock rings in various colors if they cannot produce additional embedded colors similar to the charcoal finish. A few months ago, Freddy was in contact with someone regarding powder coating cock rings, perhaps there were problems with the process as I never heard from him again regarding the powder coat experiment.



In my waxing guide, I mentioned the Mehatz tweezers. I purchase a pair with a yellow powder coat finish which would be perfect if it could be applied to a Gear Essential cock ring.

You guys are outta control - heavier? Than the Omega? Ketch, you're an animal. I haven't actually thought about a wider ring and the powder coating had a lot of problems when Gear tried it. I saw some of the examples and they were awful.

You guys are having fun with these rings aren't you?

Ketch is far more adventurous than me, that's for sure. The Omega is just about as heavy as I care to get! And I usually don't wear that one outside of sexual activity, either.

I've had very good luck (and quite a bit of fun I might add) with layering several different cockrings. I start off with my .4" Titan then a "standard" red silicone ring, then another thinner "Hardware store" stainless ring then one last silicone ring.

My next purchase will be an imperial and I'll probably grab at least 1 .2" Titan so I have more to mix and match.

I'm starting to wonder what three or four .2" Titans would feel like.....well I know what it WOULD feel like.....just waiting to find out for myself